Chicago Grip for Bare WireWarningsAlways match proper size and type of grip to application.When used on/near energized lines, ground, insulate, or isolate grip before pulling.Grips are to be used for temporary installation, not for permanent anchorage.Do not exceed rated capacity.Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.FeaturesMade in USAWorks within 0.08 to 0.20-Inch (2.0 to 5.1 mm) cable diameter rangeMax Safe Load of 1500-Pound (680 kg)Lightweight, cost-effective grip for solid and stranded #8 AWG to #6 AWG bare copper wireSingle ”V” groove jaw with 3-Inch jaw length1613-30 – spec sheet